Aeotec Heavy Duty Switch works, but "Failed at: Setting special association"

Other Devices & Integrations Power Management
#1

I just installed an Aeotec Heavy Duty Smart Switch. It works great, but on the Vera devices page it shows up with this little red error banner that says “Failed at: Setting special association”. I don’t know what that is or how to clear it. Can anyone enlighten me? Thanks!

#2

Usually this will go away once the device wakes up so give it some time. Otherwise is the device working as intended?

#3

Wakes up? It seems to be responding to commands just fine. it’s been 7 hours, still shows.

#4

Oops sorry thought it was battery operated. You could try repairing the device? Have you made any configurations to the device?

#5

I have not intentionally made any configurations. There didn’t seem to exist a product in the pairing DB for this device, so I set it up as a generic Z-wave device. It seemed to go fine, except immediately after it paired and I was able to control it, I saw that banner. It’s still showing.

#6

Set automatically configure to no

2 Likes
#7

That seems to have fixed it, thanks!