Hi, I am trying to create a scene to keep the temperature of a room between two values.
I have an electric heater controlled by a Z-Wave plug and a Fibaro FGBS-001 with a DS18B20 temperature sensor.
My first attempt used two scenes, one to switch on the heater when the sensor’s temp fell below 18 degrees, the other switching it off when the sensor reported above 20 degrees.
I found that the heater was correctly switched on by scene one, but the second scene did nothing.
I then played around with PLEG for a couple of fruitless hours.
Can someone point me in the right direction?
Cheers, Gordon