Enocean actuator via usb300 - eltako FAM14

Hello,

Am not able to figure out how to send messages to my Eltako actuators via the FAM14.

Learning in all switches from the FAM14 into ui7 works. Am able to assign them to a “swith” also… but when then using this to control an actuator via that switch" in the tool doesn’t work.

Tx

This is what I would need. Would somebody know how to make this work on Vera???

Best Home Automation shopping experience. Shop at getvera!

© 2020 Vera Control Ltd., All Rights Reserved. Terms of Use | Privacy Policy | Forum Rules