LUUP Start Up Code to set serial port

If I power cycle my Vera Plus it forgets the serial port settings which disables my connection (via AD2USB adapter) to my home alarm.

I wanted to write a couple lines of LUUP and set it as a boot up script to run at startup.

Can you control the serial port paramters via LUUP? If so any hints on the commands needed?

I need to set the serial port baud rate to 115,200 and the used by device to “A Vista Alarm Panel” which is device 126 in my system…

Best Home Automation shopping experience. Shop at getvera!

© 2020 Vera Control Ltd., All Rights Reserved. Terms of Use | Privacy Policy | Forum Rules