MIMO2+ input setup

Community Playground General Discussions
#1

I’m not sure if this is the right forum for this or not.

I’ve searched the board for MIMO2 info. I’ve found several people using the relay outputs just fine, but I haven’t seen anyone using the voltage inputs.

When paired, I get 6 devices
-parent
-rel1
-rel2
-_GET_LANG(generic_sensor,sensor)
-_GET_LANG(generic_sensor,sensor) 1
-_GET_LANG(generic_sensor,sensor) 2

The relays work as they should.

Has anyone gotten the inputs to do anything in Vera? I can get them to register on the MIMO2, and I’ve tried changing the device type to a few different sensors, but nothing in Vera.

#2

Hello,

I have opened you a support ticket in regards to this issue.

Please check your email whenever you can.

If you need further assistance please reply to that email and we will get back to you.

#3

Having the same problem. Did you ever get answer to this question? Vera support just pointed me to the MIMO2 technical bulletin, like I wouldn’t have thought of that. No help so far.

The output switch works great!