Partly Solved: Unplugged rfxcom, after connecting back it's not working anymore.

Plugins & Plugin Development USB RFXtrx Transceiver
#1

I used the rfxcommngr in Windows to program a Somfy motor. Choosing the id’s and the program option gave me the blinds going down/up a bit. Great.

Then I connected the rfxcom back to Vera, but… it’s not seen anymore. There is a LUA startup failure. HUH… it was working with KAKU 15 minutes ago.
Rebooted Vera with rfxcom connected, but…nope still nothing.

Any idea?

#2

Hmmm Got it working again. Still some advice please.

I renamed the device. So it seems I had to configure the serial port again, as the name changed.
It this once? Or do I have to configure always after a reboot?

What’s the procedure for unplugging rfcxom?

#3

I believe you had the transceiver connected previously using a different plugin. When you reconnected using the new plugin it is seen as a new device - thus the need to configure the serial port. There should be no need to do this again.

#4

Thanks.

Just tried again, pulling it out and putting it back in. Working fine.

#5

This may be the same issue I had. I removed my RFXcom and rebooted the hub. This caused it to forget the serial port config. I managed to fix it again by reconfiguring the serial port then restarting the hub.

I posted my experience here: