I’m becoming increasingly frustrated with my Vera Edge (UI7) as I need to control two of my devices via RS232 but this seems impossible for someone without programming knowledge.
I have a usb to rs232 adaptor and serial cable connected to the first device… An unbranded HDMI matrix. What I want to do is send simple hex commands to the device via serial. I have the correct baud rate, parity, etc.
I also have a Nuvo Essentia audio distribution system for which there is no plugin and would like to be able to do the same for this if anyone has any experience on this one?
Have read through the forums and there doesn’t appear to be any step by step guide on how to send a serial command or the programming code required.
I’m reasonably savvy but can’t seem to get anywhere. Why is this so hard Vera??
Any help from the community would be much appreciated! If someone could advise the process from ensuring the correct setup of the serial adaptor through to the code to execute sending the command I would be forever grateful!