Configuring "On"/"Off" Buttons on Leviton VRCZ4-M0Z Zone Controller with the Ezlo Plus Controller

I have a Leviton VRCZ4-M0Z Zone Controller that I have configured on my VeraPlus Controller to operate various scenes. The configuration of the Leviton device was done through the web browser interface to the VeraPlus Controller–using the “Scenes” option on the Device options page. In attempting to configure a second Leviton device on a new Ezlo Plus Controller, the device appears to have paired readily using the mobile interface for the Ezlo Plus, the only interface that appears to be available. Specifically, there does not appear to be a web browser interface providing a setup option similar to that available for the VeraPlus Controller that allows scenes to be set when each of the four buttons on the Leviton device is turned “off” or “on.” Under the “Z-Wave Settings” option for the Ezlo Plus Controller through its mobile interface, I can add new Z-wave parameters, but it is not clear how, if at all, this option might be used to configure the Leviton device’s buttons to operate scenes, such as can be readily done through the web browser interface to the VeraPlus Controller. Any help here for configuring the Leviton device “on” and “off” buttons to run scenes when paired to the Ezlo Plus Controller?

Best Home Automation shopping experience. Shop at getvera!

© 2020 Vera Control Ltd., All Rights Reserved. Terms of Use | Privacy Policy | Forum Rules