Fibaro FGS-223 removes loads when I change parameters

Other Devices & Integrations Lighting & Load Control
#1

Noticed something strange when I changed a parameter on my FGS-223. The parameter changed as it should but the lights I have connected disappeared from Vera UI for a minute and then came back BUT with new id:s and default name.

I haven´t noticed this behaviour before and it´s not so welcome because I have to edit all scenes and reactors where these loads are due to they get new id:s.

Has anyone else noticed this behaviour?

#2

Yep, I reported it for 7.30 beta and it’s still there.

My way of dealing with it is make a backup, configure the device and restore from backup, copying the variables by hand.

#3

Thanks for your respons!

Will try your solution next time. If Vera hasn`t fixed it with new firmware.